KOI - Rectangle Tracing

 Go back to Product Documents Navigation 

 Go back to KOI Documents Navigation 

 Go back to KOI Coding with MakeCode 

 

KOI is able to find and track rectangles in a scene.

 

 

Load the KOI Extension: https://github.com/KittenBot/pxt-koi

Loading Extensions

Blocks for circle tracing:

 

 

Sample Program

 

 

Threshold

 

Threshold affects the detection rate, testing and fine tuning the value is needed for achieving the best results.
A higher threshold value decreases interference and noise, but detection difficulty increases at the same time, please trial and fine tune for different scenarios.

 

Program Flow

Download the program to Micro:bit, then press A on the Micro:bit.
The coordinates and dimenions of the rectangle are shown on the KOI.

 

Advanced Program

The information becomes more easily readable if we add an OLED screen.

 

Connecting an OLED

Connect an OLED panel to the I2C port of your Robotbit/Armourbit.

 

 

Sample Program

Load the extension for OLED: https://github.com/KittenBot/pxt-oled

 

Sample Code

1. Rectangle Tracing (Extension0.5.7)
2. Rectangle Tracing /w OLED (Extension0.5.7)

Extension Version and Updates

There may be updates to extensions periodically, please refer to the following link to update/downgrade your extension.

Makecode Extension Update

FAQ

Q1: There is no reaction after pressing the buttons on the Micro:bit.

A1: This is because KOI has a longer boot time than Micro:bit. When the power is turned on, Micro:bit has already ran the code for KOI initialization before KOI is ready.
Solution: Reset your Micro:bit after KOI has been turned on. (The trick is to let KOI power on completely before initialization.)

Q2: Does KOI work with 3V input?

A2: No, KOI only works with 5V.

Q3: How do I improve detection rate?

  • Adjust the threshold value.
  • Keep a clean background.
  • Make sure the rectangle has a sharp outline.

 

If you have any question, please feel free to contact us at Discord, we will always be there to help.

 

KittenBot Team

 

 

 Go back to Product Documents Navigation 

 Go back to KOI Documents Navigation 

 Go back to KOI Coding with MakeCode 

Leave a comment

Please note, comments must be approved before they are published