Go back to Product Documents Navigation
Introduction
- Jacdac port
- Jacdac Communication Indicators
- Light Sensor
- Jacdac Standard Through-holes
- Product QR Code
Preparation
1× MicroUSB Cable
1× MicrobitV2 (Has to be V2)
1× Jacdaptor
1× Cable
1x Light Sensor
Connection
PC-〉MicroUSB -〉MicrobitV2-〉Jacdaptor-〉Cable-〉Light Sensor
Go to the link below
https://makecode.microbit.org/
Create a new project
Connect to the WebUSB
Add the Jacdac extension
Extensions——Jacdac
Add the Light Sensor block
Write the program and download
Press A to start after successfully downloading the program
Press A following the micro:bit LED indications to start the program
Working Status
When it is light
When it is dark
FAQ
Q1:Does this module support hot-swapping? Will hot-swapping damage the module?
A1: Yes it does support. Hot-swapping won't damage the module or the mainboard.
Q2:Does micro:bit V1.5 support Jacdac?
A2: No, it has to be V2 or versions over.
Q3:Why does Makecode not recognize the Jacdac module?
A3: Please download a blank program after loading the Jacdac extension.
Q4:Do I need to distinguish different ports for connecting modules?
A4: No, you don't need to. All ports can be used to insert any Jacdac modules.
If you have any question, please feel free to contact us at Discord, we will always be there to help.
KittenBot Team
Go back to Product Documents Navigation